Universal R-320 Operator's Manual download pdf (Page 63)

POWER MODULE SETUP SHEET

PLEASE READ CAREFULLY BEFORE INSTALLING

SWITCH #1 DELAY SELECT

OFF - NO DELAY

ON - START AND STOP DELAY SET BY FRONT PANEL CONTROLS

START CONTROL - 0 TO 1 SEC.

STOP CONTROL - 0 TO 0.1 OR 1.0 SEC. (SEE JUMP 9)

SWITCH #2 MACHINE MODE SELECT

OFF - L15 OPERATION

ON - L60 OPERATION

SWITCH #3 CLUTCH / BRAKE DELAY SELECT

[L15] SWITCH #3, W/SWITCH #2 OFF

OFF - 0 mS

ON - 25 mS

[L60] SWITCH #3, W/SWITCH #2 ON

OFF - BLOW-ON

ON - TAMP-ON

SWITCH #4 START SWITCH LOGIC LEVEL SELECT

OFF - FALLING SIGNAL EDGE ACTIVATION

ON - RISING SIGNAL EDGE ACTIVATION

SWITCH #5 STOP SWITCH LOGIC LEVEL SELECT

OFF - FALLING SIGNAL EDGE ACTIVATION

ON - RISING SIGNAL EDGE ACTIVATION

JUMPERS #6 START SWITCH TYPE SELECT

PINS 1 & 2 - SPDT START SWITCH

PINS 2 & 3 - SINGLE POLE INPUT

JUMPERS #8 SINGLE POLE START SWITCH POLARITY SELECT

PINS 1 & 2 - SWITCHES TO POSITIVE +5V TO +24V DC (PNP)

PINS 2 & 3 - SWITCHES TO GROUND (NPN)

JUMPERS #9 STOP DELAY SELECT

PINS 1 & 2 - LONG DELAY 0 TO 1 SEC.

PINS 2 & 3 - SHORT DELAY 0 TO 0.1 SEC.

DEFAULT SETTINGS

L-15 L-60

J3 J1

CODER DWELL

ADJUSTMENT

R17

JUMPERS

SWITCHES

PRINTED CIRCUIT BOARD # OO OOO OO

MONTH / NUMBER / YEAR

R-310 SL-1000

The Universal Power Module is designed to

operate the L15, L20, L30, R310, MP25, L60,

and SL1000 series of label machines. The L15,

L20, L30 and MP25 are set up the same!

The L60, R310 & SL-1000 are different,

SEE DEFAULT SETTINGS.

Coder output is adjusted by (R17) top left board

and operates in all modes. The dwell time is

adjustable from 0 to 0.5 seconds. The next

start signal or product signal will be ignored until

the coder pulse is turned off.

(NOTE) IF YOU HAVE L-60 WITH FRONT & REAR

BOARD,

THE BOARD MUST BE SET UP AS L-15.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69

Comments to this Manuals

No comments

Universal R-320 Operator's Manual Page 63

Comments to this Manuals

Related products and manuals for Label printers Universal R-320