Universal R-320 Operator's Manual download pdf (Page 16)

WEBBING THE L-15

1st. Turn the Applier switch on the control enclosure off.

2nd. Do not use a label to attach the web to the rewind spool; this will make

the

removal of the waste roll difficult.

Web the machine by looking at the webbing diagram located on the side of the

L-15 body.

1. Mount the label roll to the unwind hub. Push label roll straight back against

the unwind backing plate. Slide the label roll retainer onto the unwind hub

until it contacts the label roll. Tighten thumb screw.

2. Remove approximately 30 inches of labels from label roll backing web.

3. Route the web over brake idler roll and between the idler roll and web

drag then down through the Sensor. (See Fig.14)

Fig.14

Unwind Hub

Unwind Backing

Plate

Label Roll Retainer

Thumb

Screw

Brake Idler

Roll

Sensor

Web Drag

Idler Roll

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 68 69

No comments

Universal R-320 Operator's Manual Page 16