Universal JUNIOR ATB Owner's Manual download pdf (Page 7)

Attaching the Stabilisers (if supplied)

Ensuring that your bicycle is standing on a flat surface, slide the stabiliser bracket, followed

by the stabiliser arm, onto the protruding end of the rear wheel axle. Attach the outer axle

nut by hand and tighten using the multi-sized spanner. Do not loosen the inner axle nut.

Repeat this procedure for the other stabiliser.

1. Multi-Sized Spanner

2. Stabiliser Wheel

3. Stabiliser Arm

4. Rear Wheel Axle

5. Outer Axle Nut

To adjust the stabiliser height, use the multi-sized spanner to loosen the outer axle nut,

and slide the stabiliser arm up or down into the desired position. Re-tighten the outer

axle nut to secure into place.

1. Stabiliser Arm

2. Outer Axle Nut

3. Rear Wheel Axle

Initially, when teaching a child to ride a bicycle, there should not be a great deal of side to

side movement of the cycle. The stabilisers should be set so that both stabilisers and the

rear wheel touch the ground together. When a child becomes more confident, the

stabiliser arms / wheels can be raised so increasing the amount the bicycle can rock from

side to side.

If the stabilisers are removed, it is important that the outer axle nuts are replaced onto the

rear axle and securely tightened.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Universal JUNIOR ATB Owner's Manual Page 7