Universal JUNIOR ATB Owner's Manual download pdf (Page 19)

Cleaning: Your bicycle should be cleaned with warm soapy water (except the chain).

Rinse with clean water and dry with a soft clean cloth, afterwards oil the bicycle in the

appropriate areas.

On synthetic enamels use a good wax polish.

Handlebars: Adjust for comfort and a proper fit. Make sure that a minimum distance of

2.5” (65mm) is inserted into the headset. Securely fasten the handlebar bolt and

nut/expander bolt. Replace any worn grips.

Lubrication: To ensure that the bicycle remains in good working order, moving parts

should be regularly lubricated.

The front hub, rear hub and headset are lubricated prior to leaving the factory. Correct

further lubrication requires disassembly, cleaning and re-packing and should be done by a

qualified bicycle mechanic.

However, using a light oil or WD40 type lubricant, you may periodically oil the chain, rear

wheel sprocket, brake calliper pivots, front and rear wheel bushes, bottom bracket

bushes and headset bushes.

The calliper pivots can also be lightly oiled, but care must be taken to keep the lubricant

away from the brake blocks and wheel rims.

To avoid over lubricating, do not oil where lubricant is still evident from the previous

maintenance. Should you accidentally over lubricate, wipe clean any excess.

WARNING: Surplus oil can run down spokes and damage tyres.

NOTE: When storing your bicycle for prolonged periods, smear any chrome plating with

a light grease.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Universal JUNIOR ATB Owner's Manual Page 19